Rehabilitation of Steel Structures by Using the Rotational Friction Dampers

مهندسی عمران فردوسی

Article 10, Volume 26, Issue 2, August 2015, Pages 152-162   

Document Type: Research Note

DOI: 10.22067/civil.v26i2.49196

Author

mohammad ali Hadianfard^*

Shiraz University of Technology

Abstract

The rotational friction dampers can be improved the seismic behavior of the steel structures, and they can be reduced the internal forces in the bracing members, columns and the other structural members. In this research, a simple method for modeling and analysis of braced frames equipped by these dampers is proposed. The proposed model describes seismic behavior of dampers very well and it is applicable to analysis of braced frames with common sections in Iran. Braced steel frames with dampers and without dampers are considered for time-history dynamic analysis, and some parameters such as: base shear, axial forces of the columns and the bracing, drift of stories etc. for two different cases are compared. In the entire analyzes, the structure with damper has been shown the better performance and the more suitable seismic behavior than the structure without damper. Then, use of frictional dampers for rehabilitation of existing buildings or designing of new structures with minimum weight is very useful.

Keywords

Rehabilitation; Rotational Friction Damper; Steel Structure; Energy Dissipation

References

1. Pall, A.S. and Marsh, C., "Response of friction damped braced frames", J. Struc. Div., ASCE, 108, pp. 1313–23, (1982).

2. Aiken, I. and Kelly, S., "Earthquake simulator testing and analytical studies of two energy absorbing systems for multi-storey structures", Report No. UCB/EERC-90/03, EERC, Berkeley, (1990).

3. Aiken, J.D., Kelly, J.M. and Pall, A.S., "Seismic Response of a nine-story steel frame with friction damped cross-bracing", Report No. UCB/EERC-88/17, November, (1988).

4. Grigorian, C.E. and Popov, E.P., "Slotted bolted connection energy dissipaters", J. of Earthquake Spectra, EERI, 9(3), pp. 491–504, (1993).

5. Mualla, I.H. and Belev, B., "Performance of steel frames with a new friction damper device under earthquake excitation", J. of Eng. Struct., 24, pp. 365–371, (2002).

6. Park, J.H., Min, K.W., Chung, L., Lee, S.K., Kim, S.H. and Moon, B.W., "Equivalent linearization of a friction damper–brace system based on the probability distribution of the extremal displacement", J. of Eng. Struct., 29, pp. 1226–1237, (2007).

7. Nielsen, L. and Mualla, I.H., "A friction damping system low order behavior and design", Rapport BYG.DTUR-030, Danmarks Tekniske University, (2002).

8. Mualla, I.H., "Experimental & computational evaluation of a new friction damper device", Ph.D. Thesis, Dept. of Structural Engineering and Materials, Technical University of Denmark, (2000).