Ergonomic evaluation of tea farmers in north of Iran during plucking using body modeling

ماشین های کشاورزی

Article 19, Volume 6, Issue 2 - Serial Number 12, 2016, Pages 488-498   

Document Type: Research Article

DOI: 10.22067/jam.v6i2.34201

Authors

M. Javidi Gharache; M. Khojastehpour^*

Department of Biosystems Engineering, Ferdowsi University of Mashhad, Iran

Abstract

Introduction
People in different jobs may face skeletal problems in their body due to poor physical conditions as a result of poor working conditions and inappropriate equipment. Harvesting tea is one of those jobs that are known as a very vigorous process and it requires hard work and perseverance. Moreover, after water, tea is the most widely consumed beverage in the world. This fact highlights the great importance of jobs related to tea. The most prevailing method used for tea harvesting in Iran is manual harvesting, although this job in some regions is mechanized. Manual harvesting intensifies the hardness of this job.
Materials and Methods
This study was launched and aimed to find harmful postures in tasks related to tea plucking in order to reduce the intensities in this job. To obtain this goal workers’ postures were needed while working. Different postures should be attained by filming during a working day. Films were recorded from 30 workers in tea farms at the different parts of Lahijan region, Iran, and were analyzed by modeling tea harvesters’ bodies by CATIA software. Then, the modeled postures were analyzed by three methods: OWAS, REBA and RULA.
Results and Discussion
According to OWAS analysis, 30% of postures placed at the first level, that means the postures have not harmful effects on musculoskeletal system, and the corrective action is not required. 10% of the tea harvest labors population was placed at level 2 so the posture has harmful effects on musculoskeletal system and the corrective action is necessary in the near future. This situation is not critical, only needs more attention. The corrective actions require soon in the third level. 33% of analyzed and modeled postures were in this level. In the fourth level which is absolutely critical and has biomechanical strain with very traumatic effect on musculoskeletal system and it is necessary to exert corrective action immediately, 27% of postures were observed.
The results of REBA analysis showed that 24% of workers’ postures in tea farms and under this study were at level 1 where the risk level is low and the corrective action may be necessary to them. 53% of workers are at level 2 who are at the average risk and corrective action is necessary for them. 23% of tea harvesters are in level 3 with high level of risk, therefore the corrective action must be performed immediately. Finally, similar to results obtained from the analysis of OWAS, no posture placed at level 4. The results of RULA analysis show that there is no posture in positions 1 or 2 and all positions need to be investigated. According to this analysis, 2% of tea harvesters' postures are in position 3 and no posture in position 4. Therefore, in total, 2% were in second level. According to RULA analysis, 16% of workers' postures were in position 5. 44% of postures of tea harvesters working in different parts of Lahijan region were in position 6. Accordingly, 38% of the postures were in position 7.
Conclusions
The findings from this study showed that the highest prevalence rate of musculoskeletal pain or discomfort was in the trunk region (92%), following by the neck and upper arm (38%), lower arm (23%) and wrist (15%). For men the most frequent disorders were trunk (89%), upper arm and neck (33%), lower arm and wrist (22%). The results from this study also revealed that all women in this occupation faced musculoskeletal problems in the trunk region (100%). After trunk, neck and upper arm (57%) and lower arm (25%). No disorder was seen in wrist region in this analysis, which is consistent with female labors’ report. After this analysis finding uncomfortable postures in each duty and making changes in simulated bodies in CATIA software in order to reach a lower grand score can be helpful to improve working conditions. Reanalyzing new posture is the stage to obtain new grand score. Final step in this case is reporting harmful and improved postures to employees and employers. Notice that improved postures are not valid unless workers can have acceptable access to their work. Similarity between the results of OWAS and RULA methods and the difference from the results of REBA method could come to conclusion of not using REBA method for jobs similar to tea plucking.

Keywords

Posture analysis; Tea harvesting; Body simulation; Musculoskeletal problems

References

1. Barkhordari A., R. Jafari Nodoushan, J. Vatani Shoaa, G. H. Halvani, and M. Salmani Nodoushan. 2011. Posture evaluation using OWAS, RULA, QEC methods in fero-aleage factory workers of Kerman. Occupational Medicine Quarterly Journal 2 (1): 14-19. (In Farsi).

2. Bovenzi, M., and A. Betta. 1994. Low-back disorders in agricultural tractor drivers exposed to whole-body vibration and postural stress. Applied Ergonomics 25: 231-241.

3. Cho, Y., and Y. Yoon. 2004. Biomechanical model of human on seat with backrest for evaluating ride quality. International Journal of Industrial Ergonomics 27: 1-15.

4. Choobineh, A. 2008. Posture assessment methods in occupational ergonomics. Fanavaran Press. (In Farsi).

5. Choobineh, A., R. Tosian, Z. Alhamdi, and M. H. Zavarzani. 2004. Ergonomic intervention in carpet mending operation. Applied Ergonomics 35: 493-496.

6. Dartt, A., J. Rosecrance, F. Gerr, P. Chen, D. Anton, and L. Merlino. 2009. Reliability of assessing upper limb postures among workers performing manufacturing tasks. Applied Ergonomics 40: 371-378.

7. Fathallah, F. A. 2010. Musculoskeletal disorders in labor-intensive agriculture. Applied Ergonomics 41: 738-743.

8. Hignett, S., and L. McAtamney. 2000. Rapid entire body assessment (REBA). Applied Ergonomics 31: 201-205.

9. Hu, B., L. Ma, W. Zhang, G. Salvendy, D. Chablat, and F. Bennis. 2011. Predicting real-world ergonomic measurements by simulation in a virtual. International Journal of Industrial Ergonomics 41: 64-71.

10. Jafry, T., and D. H. O'Neill. 2000. The application of ergonomics in rural development: a review. Applied Ergonomics 31: 263-268.

11. Javidi, M. 2012. Ergonomic study and development of an appropriate biomechanical model for riceland farmhands’ body. MSc thesis. Shiraz University, Shiraz. (In Farsi).

12. Kuutti, J., and O. Oy. 1979. The short term (1–15 months) planning and control of a steel plant. Engineering and Process Economics 4: 235-243.

13. McAtamney, L., and E. N. Corlett. 1993. RULA: a survey method for the investigation of work-related upper limb disorders. Applied Ergonomics 24: 91-99.

14. Meyers, J., J. Miles, J. Faucett, I. Janowitz, D. Tejeda, V. Duraj, J. Kabashima, and R. W. E. Smith. 1998. High risk tasks for musculoskeletal disorders in agricultural field work. Paper presented at the American Public Health Association, Washington, DC.

15. Milosavljevic, S., F. Bergman, B. Rehn, and A. B. Carman. 2010. All-terrain vehicle use in agriculture: Exposure to whole body vibration and mechanical shock, Applied Ergonomics 41: 530-535.

16. Mostaghaci, M., Z. Salimi, M. Javaheri, S. F. Hoseininejad, M. Salehi, M. H. Davari, and A. H. Mehrparvar. 2012. Evaluation of the musculoskeletal disorders and its risk factors in the workers of an agricultural equipment- manufacturing plant. Occupational Medicine Quarterly Journal 3 ( 3): 19-25. (In Farsi).

17. Zhang, B., I. Horvth, J. F. M. Molenbroek, and C. Snijders. 2010. Using artificial neural networks for human body posture prediction. International Journal of Industrial Ergonomics 40 (4): 414-424.