Investigation of Short-Term Deflection in Reinforced Concrete Beams with FRP Bars

مهندسی عمران فردوسی

Article 7, Volume 31, Issue 4 - Serial Number 24, November 2018, Pages 113-130   

Document Type: Research Note

DOI: 10.22067/civil.v31i4.63819

Authors

Ali kheyroddin^* ; Fahimeh Maleki

semnan university

Abstract

One of the most important factors affecting the serviceability of structures is the deflection of concrete members. In this paper, short-term deflection of reinforced concrete (RC) beams with FRP and steel bars were studied by modeling in ABAQUS software. For different types of steel and FRP bars, twelve RC beams have been analyzed and the effective moment of inertia and deflection of the results were compared with the ACI 440.1R-15 and proposed equations. After analysis, it was found that to prevent sudden failure of RC beams with FRP bars, it is better to design a concrete beam with over reinforced sections. According to load-deflection curves of RC with FRP bars, the use of carbon FRP (CFRP) bars are the suitable alternative for steel bars in the corrosive environment. It is concluded that the use of Bischoff- Scanlon, and Bischoff- Gross equations in RC beams with glass FRP (GFRP) and aramid FRP (AFRP) with the error of less than 2% and 10%, respectively, are appropriate for determining deflection in these beams. Results indicate that any of the proposed relations for all different types of FRP rebar does not provide satisfactory results and in terms of used reinforcement special equations should be used.

Keywords

Reinforced concrete beam; Finite Element Method; FRP Bar; Deflection

References

[1] موسوی، ر.، اصفهانی، م.، رخشانی مهر، م.، "ممان اینرسی مؤثر تیرهای مسلح شده با میلگردهای " FRP. نشریه مهندسی عمران فردوسی, 24(2), 20.‎ (1392).

[2] ذبیح الهی، ح.، "بررسی رفتار خمشی و برشی پل‌های جعبه‌ای با استفاده از بتن خود متراکم مقاومت بالا(SCC) و میلگردهایFRP"، پایان نامه کارشناسی ارشد سازه،گروه مهندسی عمران، مجتمع آموزش عالی فنی و مهندسی نوشیروانی، دانشگاه مازندران. (1389).

[3] JSCE japan society of civil engineers. Standard specifications for concrete structures: design. JSCE guidelines for concrete No. 15, Tokyo. (2007).

[4] Al-Sunna, R., Pilakoutas, K., Hajirasouliha, I., & Guadagnini, M. Deflection behavior of FRP reinforced concrete beams and slabs: an experimental investigation. Composites Part B: Engineering, 43(5), 2125-2134. (2012).

[5] Imjai, T., Guadagnini, M., Garcia, R., & Pilakoutas, K. A practical method for determining shear crack induced deformation in FRP RC beams. Engineering Structures, 126, 353-364. (2016).

[6] Timinskas, E., Jakstaitė, R., Gribniak, V., Tamulėnas, V., Kaklauskas, G. Accuracy analysis of design methods for concrete beams reinforced with fiber reinforced polymer bars. Engineering Structures and Technologies, 5(3), 123-133. (2013).

[7] LST, E. Eurocode2. (2007).

[8] ACI Committee 318. Building Code Requirements for Structural Concrete (ACI 318M-11). ACI Committee 318, Farmington Hills, Michigan. (2011).

[9] NIIZhB. Concrete and reinforced concrete structures without pre stressing, SP 52-101-2003. Moscow: NIIZhB (Reinforced Concrete Research and Technology Institute). (2006).

[10] ACI Committee. Guide for the design and construction of concrete reinforced with FRP bars (ACI 440.1R-06). American Concrete Institute, Farmington Hills. (2006).

[11] CNR. Guide for the design and construction of concrete structures reinforced with Fiber-Reinforced Polymer bars, CNR-DT 203/2006. Italy: CNR (2007).

[12] Fan, X., & Zhang, M. Experimental study on flexural behavior of inorganic polymer concrete beams reinforced with basalt rebar. Composites Part B: Engineering, 93, 174-183. (2016).

[13] Hong, Z., Zhiqiang, D., Gang, W., Zhishen, W. Experimental study and theoretical calculation on the flexural stiffness of concrete beams reinforced with FRP bars. China Civil Engineering Journal, 11, 7. (2015).

[14] GB Chinese Standards. Technical code for infrastructure application of FRP composites. GB 50608, Beijing. (2010).

[15] Goldston, M. W., Remennikov, A., & Sheikh, M. N. Flexural behavior of GFRP reinforced high strength and ultra-high strength concrete beams. Construction and Building Materials, 131, 606-617. (2017).

[16] ACI Committee. Guide for the design and construction of structural concrete reinforced with FRP bars. 440.1 R. American Concrete Institute, Farmington Hills, Mich. (2015).

[17] CSA Canadian Standards Association. Design and construction of building structures with Fiber- reinforced Polymers, American Concrete Institute, Ontario, Canada, S806 –S812. (2012).

[18] Branson, D. EInstantaneous and time-dependent deflections of simple and continuous reinforced concrete Beams, HPR Report No. 7, Alabama Highway Department, Bureau of Public Roads, Montgomery, AL, Part 1, 78. (1965).

[19] Kheyroddin, A. Nonlinear finite element analysis of flexure-dominant reinforced concrete structures, Ph.D. Thesis, Dept. of Civil Eng. And Applied Mechanics, McGill University, Canada. (1996).

[20] Bischoff, P. H. Reevaluation of deflection prediction for concrete beams reinforced with steel and fiber reinforced polymer bars. Journal of Structural Engineering, 131(5), 752-767. (2005).

[21] Benmokrane, B., Chaallal, O., & Masmoudi, R. Flexural response of concrete beams reinforced with FRP reinforcing bars. ACI Structural Journal, 93(1), 46-55. (1996).

[22] Bischoff, P. H., Scanlon, A. Effective moment of inertia for calculating deflections of concrete members containing steel reinforcement and fiber-reinforced polymer reinforcement. ACI Structural Journal, 104(1), 68. (2007).

[23] Bischoff, P. H.; Gross, S. P.; and Ospina, C. E., The Story behind the proposed ACI 440 changes for prediction of deflections in reinforced concrete, Serviceability of concrete members reinforced with internal /external FRP reinforcement, American Concrete Institute, Farmington Hills, MI, 53-76. (2009).

[24] Bischoff, P. H., & Gross, S. P. Equivalent moment of inertia based on integration of curvature. Journal of Composites for Construction, 15(3), 263-273. (2010).

[25] Benmokrane, B., Chaallal, O., & Masmoudi, R. Flexural response of concrete beams reinforced with FRP reinforcing bars. ACI Structural Journal, 93(1), 46-55. (1996).

[26] Bischoff, P. H. Deflection calculation of FRP reinforced concrete beams based on modifications to the existing Branson equation. Journal of Composites for Construction, 11(1), 4-14. (2007).

[27] Bischoff, P. H, Johnson, R. D. Effect of shrinkage on short-term deflections of reinforced concrete beams and slabs. ACI Structural Journal, 105 (4): 516 – 518. (2008).

[28] ACI Committee 318. Building Code Requirements for Structural Concrete (ACI 318-08) and Commentary (ACI 318R-08). American Concrete Institute, Farmington Hills, Mich. (2008).

[29] Code, C. F. M. CEB. CEB-FIP Model Code. Design of concrete structures. Thomas Telford Services Ltd, London. (1993).