Evaluation of SALTMED Model in Simulation of Wheat Yield and Soil Salinity Variations at Saline and Nonsaline Conditions

آب و خاک

Article 12, Volume 34, Issue 4 - Serial Number 72, September 2020, Pages 933-946   

Document Type: Research Article

DOI: 10.22067/jsw.v34i4.84734

Authors

M. R. Emdad^* ; A. Tafteh

Irrigation and Soil Physics Department, Soil and Water Research Institute, Agricultural Research Education and Extension Organization (AREEO), Karaj, Iran

Abstract

Introduction: SALTMED model is one of the most practical tools for simulating soil salinity and crop production yield. Growth models are important and efficient tools for studying and evaluating the impact of different management conditions and scenarios on water, soil and plant relationships and can be used to make or predict appropriate management scenarios according to the region's conditions and to predict plant performance in the field. Since the performance of irrigation scenarios in field conditions are costly and time consuming, and due to the limited water resources in the country and the necessity of optimal water use in agriculture, using the efficient and generic models can be useful tool for simulating crop production and soil salinity variations. This research has been conducted in order to simulate soil salinity and yield production using SALTMED model in Azadegan Plain of Khuzestan province.
Materials and Methods: This study was carried out in wheat fields of Azadegan plain in Khuzestan province during 2014-2015 in three regions including Ramseh (as saline soil), Atabieh (as very saline soil) and Hamidieh (as control, non-saline soil). Three 10-hectare plots were selected in each area and a pilot with area of 2000 m2 was used for evaluation and measurement in each plot. First year data were used to calibrate the SALTMED model and second year field data were used to validate the model and to achieve the results in three conditions. The dominant soil texture in the area was clay loam. The quality of used irrigation water with average salinity of 2 dSm-1 was classified as C3-S1(high salinity with low sodium absorption ratio) and had no effect on wheat yield loss. In this study, version 3-04-25(2018) of SALTMED model was used and after calibrating in the first year, the results of simulated wheat grain yield and soil salinity variation values were used for model validation in different regions and in soils with different degrees of salinity, in the second year.
Results and Discussion: The average measured and simulated biomass yield in the first year were 6.6 and 6.1 t/ha, respectively. Furthermore, the average of measured and simulated of wheat grain yield was 2.9 and 2.6 t/ha, respectively. Some statistical indices including mean bias error, normalized root mean square error, and root mean square error for grain yield were 0.11, 0.04, and 0.12 t/ha, respectively. The values of the same statistical parameters for biomass were -0.49, 0.1, and 0.61t/ha, respectively. These results showed that the measured values of grain yield and wheat biomass were in good agreement with the simulated values using SALTMED model. The simulated and measured variations of soil salinity at three soil depths of  0-30, 30-60, and 60-90 cm, showed close agreement with each other in three layers. Root mean square error, normalized root mean square error, and mean bias error  for soil salinity values were 1.3, 0.20, and -0.06, respectively. After calibrating the model in the first year, to validate this model in the second year, the results of three pilots locations in three regions of Ramseh (saline), Atabieh(very saline) and Hamidieh(non-saline) were used. Comparison of simulated and measured wheat grain yield and biomass values showed that there was no significant difference between simulated and measured values. The simulated values of grain yield and wheat biomass in the three non-saline, saline and very saline soils had high correlation with the measured values, indicating high accuracy and efficiency of this model in simulating grain and biomass yield in different degrees of soil salinity. Moreover, the trend of soil salinity changes simulated by the SALTMED model in three highly saline, saline and non-saline soils (for three soil layers) was close to the measured values. The SALTMED model with normalized root mean square error and mean bias error of 0.18 and -0.13, respectively, showed good accuracy in different salinity conditions. There was no significant difference (5% level) between the measured and simulated salinity values of the different soil layers. The mean standard error at the 0-30, 30-60, and 60-90 cm layers was 1.1, 1.05, and 0.81 dSm-1, respectively. Therefore, based on the results and statistical indices, it was found that SALTMED model had good accuracy and efficiency in simulating yield, biomass and soil salinity under different salinity conditions.
Conclusion: According to the results and statistical indices, SALTMED model had good performance and accuracy in simulating grain yield, biomass and soil salinity variations in different soil salinity conditions and so it can be used to predict wheat yield, yield components and soil salinity in different soil condition with different degrees of soil salinity to sustain soil and water and improve water productivity in similar areas.

Keywords

Biomass; Calibration; grain yield; Khuzestan; Validation

References

1- Allen R.G., Pereira L.S., Raes D., and Smith M. 1998. Crop Evapotranspiration, FAO Irrigation and Drainage Paper No 56. Rome, Italy. 300: 6541

2- Aly A.A., Al-Omran A.M., and Khasha A.A. 2015. Water management for cucumber: Greenhouse experiment in Saudi Arabia and modeling study using Saltmed model. Soil and Water Conservation 70(1): 1-11.

3- Cardon E.G., and Letey J. 1992. Plant water uptake terms evaluated for soil water and solute movement models. Soil Science Society American Journal 56: 1876-1880.

4- Dastranj M., Noshadi M., Sepaskhah A.R., Razzaghi F., and Ragab R. 2018. Soil salinity and tomato yield simulation using Saltmed Model in drip Irrigation. Irrigation and Drainage Engineering 144(2): 7001-7022.

5- Geerts S., Raes D., Garcia M., Miranda R., Cusicanqui J.A., Taboada C., Mendoza J., Huanca R., Mamani A., Condori O., Mamani J., Morales B., Osco V., and Steduto P. 2009. Simulating yield response of Quinoa to water availability with AquaCrop. Agronomy Journal 101: 499–508.

6- Golabi M., Naseri A.A., and Kashkuli H.A. 2009. Evaluation of Saltmed model performance in irrigation and drainage of sugarcane farms in Khuzestan province of Iran. Food. Agriculture and Environment 7(2): 874-880.

7- Hassanli M., Ebrahimian H., Mohammadi E., Rahimi A., and Shokouhi A. 2016.Simulating maize yields when irrigating with saline water, using the Aquacrop, SALTMED, and SWAP models. Agricultural Water Management 176: 91-99.

8- Hassanli M., Afrasiab P., and Ebrahimian H. 2015. Evaluation of AquaCrop vs SALTMED model to estimate crop yield and soil salinity. Iranian. Journal Soil and Water Research 46(3): 487-498. (In Persian with English abstract)

9- Heidarinia M., Boroomand Nasab S., Naseri A., and Albaji M. 2017.AquaCrop model evaluation to estimate of Maize yield and soil salinity under different agriculture managements and irrigation with saline water. Iranian. Journal Soil and Water Research 48(1): 49-61. (In Persian with English abstract)

10- Hirich A., Choukr-Allah R., Ragab R., Jacobsen S.E., El Youssfi L., and El Omari H. 2012.The SALTMED model calibration and validation using field data from Morocco. Environal. Science 3: 342-359.

11- Mohammadi M., Davari K., Ghahreman B., Ansari H., and Haghverdi A. 2015. Calibration and validation of AquaCrop model for the simulation of spring wheat yield under simultaneous stress of salinity and drought. Water Research in Agriculture 29(3): 277-295. (In Persian with English abstract)

12- Nasrollahi A., Hooshmand A., and Heydarinia M. 2016. Evaluation of the SALTMED model under different managements of drip irrigation with saline water. Iranian. Journal Soil and Water Research 47(3): 561-567. (In Persian with English abstract)

13- Rameshwaran P., Tepe A., Yazar A., and Ragab R. 2014. The effect of saline irrigation water on the yield of pepper. Experimental and modeling study. Wiley Online Library: Retrieved February18. 2015. from http:doi/ 10. 1002/ird.1867///onlinelibrary.wiley.com. 64(1):41-49.

14- Ragab R., Malash N., Abdel Gawad G., Arsalan A., and Ghaibeh A. 2005. A holistic generic integrated approach for irrigation, crop and field management The Saltmed model validation using field data of five growing seasons from Egypt and Syria. Agricultural Water Management 78: 89-107.

15- Ragab R. 2015. Integrated Management Tool for Water, Crop, Soil and N‐Fertilizers: The Saltmed Model. Irrigation and Drainage 64(1): 1-12.

16- Ranjbar G.H., Ghadiri H., Razzaghi F., Sepaskhah A.R., and Edalat M. 2015. Evaluation of the SALTMED model for sorghum. International Journal of Plant Production 9(3): 373-392.

17- Razzaghi F., Plauborg F., Ahmadi S.H. Jacobsen S-E. Anderson M. N. and Ragab R. 2011.Simulation of quinoa (Chinopodium quinoa wild.) response to soil salinity using the Saltmed model. ICID 21st International Congress on Irrigation and Drainage.15-23 Oct.Tehran, Iran 56(3): 25-32.

18- Silva L.L., Ragab R., Duarte I., Lourenc E., Simo˜es N., and Chaves N.N. 2013.Calibration and validation of Saltmed model under dry and wet year conditions using chickpea field data from Southern Portugal. Irrigation Science 31: 651–659.

19- Todorvic M., Albrizio R., Zivotic L., Abi Saab M., Stocle C., and Steduto P. 2009. Assesment of Aquacrop, Cropsyst, and Wofost models in the simulation of sunflower Growth under different water regimes. Agronomy Journal 101: 509-521.

20- Ziaii G., Babazade, H., Abbas, F., and Kaveh F. 2014. Evaluation of the Aquacrop and CERES-Maize models in assessment of soil water balance and maize yield. Iranian Journal of Soil and Water Research 45(4): 435-445. (In Persian with English abstract)