Effect of Presence LDPE on Mechanical and Electrical Properties of CB/HDPE Segregated Structure

مهندسی متالورژی و مواد

Article 11, Volume 34, Issue 4 - Serial Number 32, December 2023, Pages 59-70   

Document Type: Original Articles

DOI: 10.22067/jmme.2023.83646.1118

Authors

seyed mehran teimoury; samane sahebian^* ; Seyed Abdolkarim Sajjadi

Department of Material science and Engineering, faculty of engineering, Ferdowsi university of Mashhad, Mashhad, Iran.

Abstract

Considering the application of conductive polymer composites with segregated structure in electronics and aerospace industries, there is important to investigate their mechanical properties. In this research, High Density Polyethylene (HDPE), Carbon Black (CB) as conductive phase and Low Density Polyethylene (LDPE) were used as reinforcing phase to make composite. For Sample preparation first, mechanical mixing and hot pressing was selected. The conductivity of the samples was measured to ensure the formation of segregated structure. The results showed that the conductivity in composites with segregated structure has more conductivity than the polymer matrix and composites with random distribution.

Analysis of microscopic images also confirmed the results of electrical conductivity. carbon black compeletely covered the surface of HDPE granuls.Besides, the mechanical properties was performed by tensile strength test. The addition of CB phase alone improved the yield strength and Young's modulus, while the addition of 0.5% CB had no effect on the improvement.

Keywords

Segregated Structure; Mechanical Properties; Electrical Conductivity; Conductive Polymer Composites; Yield Strength; Young'; s Modulus

References

[1]   J. Tiusanen., D. Vlasveld., J. Vuorinen., "Review on the effects of injection moulding parameters on the electrical resistivity of carbon nanotube filled polymer parts", Composites Science and Technology, vol. 72, no. 14, pp. 1741-1752, (2021).

 [2] H. Pang, L. Xu, D-X Yan, Z-Ming, "Conductive polymer composites with segregated structures", Progress in Polymer Science, Vol. 39, Issue 11, pp. 1908-1933, (2014).

[3]   J. C. Grunlan, W. W.Gerberich, L. F.Francis, “Lowering the percolation threshold of conductive composites using particulate polymer microstructure", J Appl Polym Sci, Vol. 80, pp. 692–705. (2001).

[4]   J. C. Grunlan, W. W.Gerberich, L. F.Francis,  "Electrical and mechanical behavior of carbon black-filled poly(vinyl acetate) latex-based composites", Polym Eng Sci, Vol. 41, pp. 1947–62, (2001).

[5]   H. Pang, D. X.Yan, Y Bao, J. B.Chen,  C.Chen,  Z. M.Li,  "Super-tough conducting nanotube/ultrahigh-molecular-weight polyethylene composites with segregated and double-percolated structure", Journal Mater Chemistry, Vol. 22, pp. 23568–75. (2012).

[6]   H.Zois, L.Apekis, M.Omastova, "Electrical Properties of Carbon Black-filled Polymer Composites", Macromolecular Symposia, Vol. 170, pp. 249-256, (2001).

[7]    S.Gupta, R.Ou, and R.A.Gerhardt, "Effect of the fabrication method on the electrical properties of poly(acrylonitrile-co-butadiene-costyrene)/carbon black composites", Journal Electronic Materials, Vol. 35, pp.
224–229, (2006).

[8]    Q.Liu, J.Tu, X.Wang, W.Yu, W.Zheng, Z.Zhao, "Electrical conductivity of carbon nanotube/poly(vinylidene fluoride) composites prepared by high-speed mechanical mixing", Carbon, Vol. 50, pp. 339-341, (2012).

[9]    W. Ch.Yu, T.Wang, , G.Q.Zhang, Z. G.Wang,  H. M.Yin, D. X. Yan,  J. Zh. Xu,, Z. M. Li, "Largely enhanced mechanical property of segregated carbon nanotube/ poly (vinylidene fluoride) composites with high electromagnetic interference shielding performance", Composites Science and Technology, Vol. 167, pp. 260-267, (2018).

[10] Y.S.Kim, "Electrical Conductivity of Segregated Network Polymer Nanocomposites", (2007).

[11] D. Xu, , Ch. Wenhua, L. Pengju, "Enhanced electromagnetic interference shielding and mechanical properties of segregated polymer/carbon nanotube composite via selective microwave sintering", Composites Science and Technology, Vol. 199, pp. 108–355, (2020).

[12] T. Jiahong, Y. Fan, X. Yeping, L. Pengju, "Improved mechanical and electromagnetic interference shielding performance of segregated UHMWPE/CNTs via microwave-assisted sintering", High Performance Polymer, pp. 1140-1149, (2020.

[13] S. Moazen, S. Sahebian, M. Haddad Sabzevar, “Low percolation behavior of HDPE/CNT nanocomposites for EMI shielding application: Random distribution to segregated structure", Synthetic Metals, Vol. 281, 116900, (2021).