Evaluating the influence of number of layers and concentration of carboxy-methyl cellulose and carrageenan coating on osmotic dehydration performance of Golden delicious apple

مجله پژوهشهای علوم و صنایع غذایی ایران

Article 33, Volume 13, Issue 5 - Serial Number 47, November and December 2017, Pages 680-690   

Document Type: Research Article

DOI: 10.22067/ifstrj.v1395i0.45890

Authors

Elham Sadati gol afshani¹; Seyed Mahdi Jafari¹; Mahdi Kashani-Nejad¹; Shahram Beiraghi-Toosi²; Mohammad Ganjeh^{* 1}

¹Faculty of Food Science and Technology, Gorgan University of Agricultural Sciences and Natural Resources, Gorgan, Iran.

²Food Processing Research Department, Food Science and Technology Research Institute, ACECR (Iranian Academic Center for Education, Culture and Research), Mashhad, Iran.

Abstract

Introduction: Osmotic dehydration involves the partial removal of water by direct contact of a product with a hypertonic medium such as high concentration of sugar, salt or sugar-salt solutions. In this process, food pieces are immersed in a hypertonic solution. The natural membrane of food cells acts as a semipermeable layer so the water moves across the membrane from an area of high water potential (low solute concentration) to an area of low water potential (high solute concentration), meaning the driving force for water removal is the concentration gradient between the solution and the intracellular fluid. During osmotic dehydration, osmotic solute is absorbed by food materials and has undesirable effects on water removal, nutritional and organoleptic properties. Use of coating improves the osmotic processing. Best factor for evaluation of coating material is performance ratio (WL/SG). So a coating should reduce solid uptake without negative effects on water removal.

Materials and methods: The apples (Golden delicious) used in this study were purchased from a local market in Mashhad (Iran) and stored at 4-6°C before processing. The sucrose (99.9%, Fariman sugar company, Iran), carrageenan (kappa type, Negin Khorak Pars Company, Iran), carboxy methyl cellulose (sandros, Japan) and calcium chloride (Dr. Mojallali Lab., Iran) were also used. In this work, apple cubes were single and double coated in three concentrations (0.5, 1 and 1.5% w/w) of carboxy methyl cellulose (CMC) and carrageenan solution and dehydrated osmotically in different concentrations (30, 45 and 60˚ BX) of sucrose solutions.

Results and Discussion: The results of this study indicated that increasing coating solution concentration from 0.5% to 1.5% decreased water loss. Also the water loss increased when the number of coating layers and the concentration of osmotic solution increased (from 30 to 60 ˚ BX). Generally, water loss and solids uptake in the samples coated with carrageenan was higher and lower than their CMC counterparts, respectively. The solids uptake in the samples coated with CMC increased by increasing the number of layers, osmotic solution concentration (from 30 to 60˚BX) and coating solution concentration (from 0.5 to 1.5%). The solids uptake increased and decreased with increase in layer number and coating solution concentration (from 0.5% to 1.5%), respectively. Increasing the osmotic solution concentration up to 45 ˚ BX increased solids uptake but, more increasingly did not have a significant effect on it. Finally, it cannot be said strictly that one coating type would facilitate osmotic process or not. It depends on various process factors. Among the 36 treatments studied in this research, the single coated samples with 1% carrageenan treated in 60 ˚ BX sucrose solution and the single and double coated samples with 0.5% CMC treated in 45 ˚ BX sucrose solution were the best, as they had 50% higher performance ratio than control (uncoated) sample.

Keywords

Coating; Solids uptake; Golden delicious apple; Osmotic Dehydration

References

Debeaufort, F., Quezada-Gallo J., 1998, Edible Films and Coatings: Tomorrow's Packagings: A Review Critical Reviews. Food Science and Nutrition, 38(4): 299-313.

Dehghannya, J., Emam-Djomeh, Z., 2006. Osmotic Dehydration of Apple Slices with Carboxy-Methyl Cellulose Coting. Drying Technology, 24, 45-50.

Farzaneh1, P., Fatemian, H., Hosseini1 E., Asadi1, Gh. H., and Darvish, F., 2011, A Comparative Study on Drying and Coating of Osmotic Treated Apple Rings. International Journal of Agricultural Science and Research, 2, 2.

Garcia, M., Diaz, R., Martinez, Y., Casariego, A., 2010, Effects of chitosan coating on mass transfer during osmotic dehydration of papaya. Food Research International 43: 1656–1660.

Jalaee, F., Fazeil, A., Fatemain, H., Tavakolipour, H, 2010, Mass transfer coefficient and the characteristics of coated apples in osmotic dehydrating, Food and Bioproducts Processing 89, 367- 374.

Jena, S., Das, H., 2005, Modeling for moisture variation during osmo-concentration in apple and pineapple. Journal of Food Engineering, 66, 425-432.

Khin, M. M., Zhou, W., 2005, Development in the Combined Treatment of Coating and Osmotic Dehydration of Food- A Review. Journal of Food Engineering, 1(1), Article 4.

Khin, M. M., Zhou, W., 2006, A study of the mass transfer in osmotic dehydration of coated potato cubes. Journal of Food Engineering, 77(1), 84-95.

Khin, M. M., Zhou, W., 2007, Mass transfer in the osmotic dehydration of coated apple cubes by using maltodextrin as the coating material and their textural properties. Journal of Food Engineering, 81(3), 514-522.

Lazarides, H. N., Mitrakas, G. E., 2007, Edible coating and counter-current product/solution contacting: A novel approach to monitoring solids uptake during osmotic dehydration of a model food system. Journal of Food Engineering, 82(2), 171-177.

Lenart, A., Dabrowska, R., 1999, Khinetics of osmotic dehydration of apple with pectin coatings. Drying technology An International, 17(7), 1359- 1373.

Mandala, I. G., Anagnostaras, E. F., 2005, Influence of osmotic dehydration conditions on apple air-drying kinetics and their quality characteristics. Journal of Food Engineering, 69(3), 307- 316.

Matuska, M., Lenart, A., 2006, on the use of edible coatings to monitor osmotic dehydration kinetics for minimal solids uptake. Journal of Food Engineering, 72(1), 85-91.

Mundada, M., Singh Hathan, B. and Maske S, 2011, Mass Transfer Kinetics during Osmotic Dehydration of Pomegranate Arils. Journal of Food Science, 76(1).

Nieto, B. M., 2009, Structure and Function of Polysaccharide Gum-Based Edible Films and Coatings.In: Edible Films and Coatings for Food Applications. Eds. Embuscado, E.E., Huber, K.C. Springer. P: 57-112.

Silva, M., Zaqueu Ernesto da Silva, Z. E, Mariani, V. C, Darche, S., 2012, Mass transfer during the osmotic dehydration of West Indian cherry. LWT - Food Science and Technology 45.