Rheological properties of strawberry fruit coating with methylcellulose

ماشین های کشاورزی

Article 14, Volume 6, Issue 1 - Serial Number 11, 2016, Pages 153-162   

Document Type: Research Article

DOI: 10.22067/jam.v6i1.31349

Authors

Z. Nadim; E. Ahmadi^*

Department of Biosystem Engineering, Faculty of Agriculture, Bu-Ali Sina University, Hamedan, Iran

Abstract

Introduction: The maintenance of the quality of fresh products is still a major challenge for the consumers. The most important quality attributes contributing to the marketability of fresh fruit include appearance, color, texture, flavor, nutritional value and microbial safety. Strawberry fruits should be firm but not crunchy. Decreased quality during postharvest handling is most often associated with water loss and decay. The postharvest life of strawberries can be extended by coating technique combined with refrigeration. Application of edible coatings is a conventional method to increase shelf life and maintain fruit quality. Edible coatings can provide an alternative to enlarge fresh fruits’ postharvest life. In this study, the effects of application of methyl cellulose edible coatings and storage time on some mechanical properties, including: the yield stress, yield strain, energy of rupture and modulus of elasticity and also, the viscoelastic behavior of the strawberry fruit was investigated.
Materials and Methods: MC (Methocel, Dow Chemical Company, Midland, MI) coating was prepared by solubilizing MC powder (3.0 g per 100 mL) in a water–ethyl alcohol mixture (2:1) at 75ºC under the high speedmixer (900 rpm) for 15 min. Coatings were used directly on the fruit surface. The physical and mechanical characteristics of fruits were analyzed on 2, 5, 8 and 11 days of storage. The puncture test and relaxation test were done using a texture analyzer (Zwick/Roell Model BT1_FR0.5TH.D14, Zwick GmbH Co., Ulm, Germany; using Xforce HP model of loadcell with capacity of 500 N, by 2 mv/v characteristic). General Maxwell model is widely used to analyze experimental results of the stress tests applied for relaxation. The obtained model coefficients were determined and evaluated from relaxation stress curves. Residues were determined using the sequential model. Usually, multicomponent models can properly describe the actual behavior of agricultural products. Results of factorial experiment in a completely randomized design were analyzed. In this study, the stress versus time graph was plotted and three-component Maxwell model coefficients were obtained.
Results and Discussion: In this current study, application of MC significantly reduced the fresh strawberries decay. Fruit decay in strawberries increased with storage time, but the coating reduced rate of decay with the length of storage. According to the results, the application of these coatings has a positive impact on yield stress and energy of rupture product texture during the storage. Average yield stress and rupture energy for the coated samples and control were 0.11, 5.71 and 0.09, 4.12 MPa respectively. The effect of treatment and storage time on the yield strain and elastic modulus were not statistically significant. The results show that provided Maxwell model satisfactorily (RMSE0.96) fits the experimental data. Also, with a retention time, the elastic component of the model is relatively reduced and the application of the coating prevents the decrease in relaxation time and improves the rheological properties of fruit. Relaxation time is different based on the characteristics of the viscoelastic or viscous substances, but this time is wider in elastic material. The relaxation time depends on the moisture content of the product, so the increase of humidity and soft, reduced relaxation time. Coatings are effective physical barrier to moisture loss and slower rates of weight loss in coated fruits because of the cover features for gas diffusion of stomata, the organelles that regulate the transpiration process and gas exchange between the fruit and the surroundings.
Conclusions: Edible films and coatings may reduce the moisture transfer, the rate of oxidation and respiration which are considered important to prolong the shelf-life of these products. This investigation showed that the MC coatings are effective for strawberries shelf life extension and retarded the senescence process in compared with control. The coat has been as a physical barrier for the gas exchange between the fruit and the environment. It was demonstrated that the coating reduced loss of firmness and delayed the softening of fruit and texture change. Fruit decay in strawberries increased with storage time, but the coating reduced rate of decay with the length of storage. Finally the results showed that coating, may increase overall acceptability, and increase the quality and shelf life of fruits.

Keywords

Edible coatings; Strawberry; Stress relaxation; Viscoelastic Properties; Yield stress

References

1. Bravin, B., D. Peressini, and A. Sensidoni. 2004. Influence of emulsifier type and content on functional properties of polysaccharide lipid based edible films. Journal of Agricultural and Food Chemistry 52: 6448-6455.

2. Del Nobile, M. A., S. Chillo, A. Mentana, and A. Baiano. 2007. Use of the generalized Maxwell model for describing the stress relaxation behavior of solid-like foods. Journal of Food Engineering 78: 987-983.

3. Hagenmaier, R. D., and P. E. Shaw. 1990. Moisture permeability of edible films made with fatty acid and (hydroxypropyl) methylcellulose. Journal of Agriculture and Food Chemistry 38: 1799-1803.

4. Hassanpour, A., M. Esmaiili, A. Modarres Motlagh, and A. Rahmani Didar. 2011. Changes in viscoelastic properties of Thompson seedless grapes during ripening. Journal of Food Researches 2: 133-145. (In Farsi).

5. Galetto, C. D., R. A. Verdini, S. E. Zorrilla, and A. C. Rubiolo. 2010. Freezing of strawberries by immersion in CaCl2 solutions. Food Chemistry 123: 243-248.

6. Ghasemi baghbadrani, B., and A. Hemmat. 2012. Effect of cultivar and harvest time on viscoelastic properties of apple. The 8th National Congress on Agriculture Machinery Engineering (Biosystem) & Mechanization. Mashhad, Iran. (In Farsi).

7. Jafarian, M., H. Sadrnia, and M. H. Aghkhani. 2013. Study the effect of CaCl2.2H2O on mechanical properties of apple in storage time. Journal of Agricultural Machinery 2: 133-143. (In Farsi).

8. Kajuna, S., W. K. Bilanski, and G. S. Mittal. 1998. Effect of ripening on the parameters of three stress relaxation models for banana and plantain. Transactions of the ASAE 41: 55-61.

9. Kashaninejad, H., H. Pourazarang, A. Mortazavi, and Y. Maghsoudlou. 2005. Effect of pressure infiltration of calcium chloride on shelf life elongation of apple varieties. Agricultural Sciences and Natural Resources 3: 52-60. (In Farsi).

10. Khazaei, J., and D. D. Mann. 2005. Effects of moisture content and number of loadings on force relaxation behaviour of chickpea kernels. International Agrophysics 19: 305-313.

11. Maftoonazad, N., and H. S. Ramaswamy. 2005. Postharvest shelf-life extension of avocados using methyl cellulose-based coating. LWT Food Science and Technology 38: 617-624.

12. Maghoumi, M., Y. Mostofy, A. R. Talaiy, M. Dehestani, and A. Asghari. 2010. Effect of modified atmosphere packaging with high carbon dioxide on strawberry shelf-life features. Journal of Agricultural 11: 163-176.

13. Mohsenin, N. N. 1986. Physical properties of plant and animal materials: structure, physical characteristics and mechanical properties. 2nd ed., Gordon Breach Science Publisher, New York.

14. Nadim, Z., E. Ahmadi, H. Sarikhani, and R. Amiri Chayjan. 2015. Effect of methylcellulose-based edible coating on strawberry fruit’s quality maintenance during storage. Journal of Food Processing and Preservation 39: 80-90.

15. Navarro-Tarazaga, M. L., A. Massa, and M. B. Perez-Gago. 2011. Effect of beeswax content on hydroxypropyl methylcellulose-based edible film properties and postharvest quality of coated plums (Cv. Angeleno). Food Science and Technology 44: 2328-2334.

16. Razavi, S. M. A., and R. Akbari. 2007. Biophysical properties of agricultural and food materials. Ferdosi University of Mashad Publisher, Iran. (In Farsi).

17. Tavakkoli Hashjin, T. 2004. Mechanics agricultural. First Printing. Zanjan University Publisher, Zanjan, Iran. (In Farsi).

18. Van Vliet, T. 1999. Rheological classification of foods and instrumental techniques for their study. In A.J. Rosenthal (Ed.), Food Texture Measurement and Perception (pp. 65-98). New York: Aspen.