Simulation of the Forced Convection Heat Transfer Non-Newtonian Nanofluid, Aqueous Solution of Carboxymethyl Cellulose-Aluminum Oxide, in Slip Flow Regime Through a Microtube

علوم کاربردی و محاسباتی در مکانیک

Article 4, Volume 28, Issue 1 - Serial Number 15, March 2017, Pages 47-62   

Document Type: Original Article

DOI: 10.22067/fum-mech.v28i1.48222

Authors

seyed ali sajadifar¹; arash karimipour^{* 1}; davood toghraei²

¹najafabad

²khomeinishahr

Abstract

At present study the flow and heat transfer of Non-Newtonian nanofluid, aqueous solution of carboxymethyl cellulose-Aluminum oxide with different volume fractions of nano particles in a two dimensional microtube is simulated for the first time. Slip velocity and temperature jump boundary conditions are also considered along the microtube walls. The achieved results accuracy is investigated by comparison with those of previous data. The results are presented as isothermal contours, Nusselt number and the profiles of temperature and velocity at different cross sections of the microtube. It is observed that Nusselt number increases with slip velocity coefficient and volume fraction of nano particles; while its rate is more sensitive at higher values of Reynolds number.

Keywords

Non-Newtonian nanofluid; Micro tube; Slip velocity; Temperature jump

Supplementary Files

4-sajjadifar-EA.pdf

References

1. Li, J. and Kleinstreuer, C., "Thermal performance of nanofluid flow in microchannels", International Journal of Heat and Fluid Flow, Vol. 29, pp. 1221-1232, (2008).

2. Pawan Singh, K., Harikrishna, P.V., Sundararajan, T. and Sarit Das, K.," Experimental and numerical investigation into the hydrodynamics of nanofluids in microchannels", Experimental Thermal and Fluid Science, Vol. 42, pp. 174-186, (2012).

3. Jung, Ju., Oh, H. and Kwak, H., "Forced convective heat transfer of nanofluids in microchannels", International Journal of Heat and Mass Transfer, Vol. 52, pp. 466-472, (2009).

4. Aminossadati, S.M., Raisi, A. and Ghasemi, B., "Effect of magnetic field on nanofluid forced convection in a partially heated microchannel", International Journal of Non-Linear Mechanics, Vol. 46, pp. 1373-1382, (2011).

5. Shariat, M., HosseinNezhad, A.A., Behzadmehr, A. and Laur, R., "Numerical study of two phase laminar mixed convection nanofluid in elliptic ducts", Applied Thermal Engineering, Vol. 31, pp. 2348-2359, (2011)

6. Gad-el Hak, M., “Flow physics in MEMS”, Rev. Mec. Ind., 2, 313-341, (2001).

7. Adams, T.M., Abdel-Khalik, S.I., Jeter, S.I. and Qureshi, Z.H., “An experimental investigation of single-phase forced convection in microchannel”, International Journal of Heat and Mass Transfer, Vol. 41, pp. 851-857, (1998).

8. Xuan, Y., Li, Q. and Ye, M., "Investigation of convection heat transfer in ferrofluidmicroflows using lattice-Boltzmann approach", International Journal of Heat and Mass Transfer Thermal Sciences, Vol. 46, pp. 105-111, (2007).

9. Ho, C. and Tia, Y., "Micro-electro-mechanical-system(MEMS) And fluid flows", Annu. Rev. Fluid Mech., Vol. 30, pp. 579-612, (1998).

10. Keshavarz, M., Hossein Haddad, S.M. and Darabi, M., "Modeling of Force Convection Heat Transfer of a Non-Newtonian Nanofluid in the Horizintal Tube Under Constant Heat Flux With Computational Fluid Dynamics", Internatinal Communications in Heat and Mass Transfer, Vol. 39, pp. 995-999, (2012).

11. Choi, Z. and Zhang, Y., "Numerical simulation of laminar forced convection heat transfer Al2O3–water nanofluid in a pipe with return bend", Vol. 55, pp. 90-102, (2012).

12. Tahir, S. and Mital, M., "Numerical investigation of laminar nanofluid developing flow and heat transfer in a circular channel", Applied Thermal Engineering, Vol. 39, pp. 8-14, (2012).

13. Akbarinia, A. and Laur, R., "Investigating the diameter of solid particles effects on a laminar nanofluid flow in a curved tube using a two phase approach", International Journal of Heat and Fluid flow, Vol. 30, pp. 706-718, (2009).

14. Hojati, M., Etemad, S.GH., Bagheri, R. and Thibault, J., "Convection Heat Transfer of Non-Newtonian Nanofluid Through a Uniformly Circular Tube", Experrimental Thermal and Fluid Science, Vol. 35, pp. 1351-1356, (2011).

15. Kumar P. and Ganesan, R., "A CFD Study of Turbulent Convection Heat Transfer Enhancement in Circular Pipeflow", Internatinal Journal of Civil and Envirronmental Engineering, Vol. 7, pp. 385-392, (2012).

16. Akbarinia, A., Abdolzadeh, M. and Laur, R., "Critical investigation of heat transfer enhancement using nanofluids in microchannels with slip and non-slip flow regimes", Applied Thermal Engineering, Vol. 31, pp. 556-565, (2011).

17. ChidanandMangrulkar, K. and VilayatraiKriplani, M., "Nanofluid Heat Transfer-A Review", International Journal of Engineering and Technology, Vol. 3, pp. 136-142, (2013).

18. Santra, A., Sen, S. and Chakraborty, N., "Study of Heat Transfer Due to Lminar Flow of Copper-Water Nanofluid Through Two Isothermally Heated Parallel Plates", Internatinal Journal of Thermal Sciences, Vol. 48, pp. 391-400, (2009).

19. Barkhordari, M. and Etemad, S.GH., "Numerical Study of Slip Flow Heat Transfer of Non-Newtonian Fluids in Circular Microchanels", Internatinal Journal of Heat nad Fluid Flow, Vol. 28, pp. 1027-1033, (2007).

20. Behzadmehr, A., Saffar-Avval, M. and Galanis, N., "Prediction of turbulent forced convection of a nanofluid in a tube with uniform heat flux using a two phase approach", International Journal of Heat and Fluid Flow, Vol. 28, pp. 211-219, (2007).

21. Ding, Y., Alias, H., Wen, D. and Williams, R., "Heat Transfer of Aqueous Suspension of Carbon Nanotube", Internatinal Journal of Heat and Mass Transfer, Vol. 49, pp. 240-250, (2006).

22. Raisi, A., Ghasemi, B., S Aminossadati, M., "A Numerical Study on the Forced Convection of Laminar Nanofluid in a Microchannel with Both Slip and No-Slip Conditions", International Journal of Computation and Methodology, Vol. 59, pp. 114-129, (2012).

23. Rahman, M.M., Al-Lawatia, M.A., Eltayeb, I.A. and Al-Salti, N., "Hydromagnetic slip flow of water based nanofluids past a wedge with convective surface in the presence of heat generation or absorption", Internatinal Journal of Nonlinear Mechanics, Vol. 46, pp. 1373-1382, (2011).

24. Ahmed, M.A., Shuaib, N.H., Yusoff, M.Z. and Al-Falahi, A.H., "Numerical investigations of flow and heat transfer enhancement in a corrugated channel using nanofluid", International Communications in Heat and Mass Transfer, Vol. 38, pp. 1368-1375, (2011).

25. Jung, J., Oh, H. and Kwak, H., "Forced convective heat transfer of nanofluids in microchannels", International Journal of Heat and Mass Transfer, Vol. 52, pp. 466-472, (2009).

26. Afshar, H., Shams, M., Nainian, S.M.M. and Ahmadi, G., "Microchannel heat transfer and dispersion of nanoparticles in slip flow regime with constant heat flux", International Communications in Heat and Mass Transfer, Vol. 36, pp. 1060-1066, (2009).

27. Kalteh, M. and Abbassi Saffar-Avval, A.,M.,J., "Eulerian-Eulerian two-phase numerical simulation of nanofluid laminar forced convection in a microchannel", International Journal of Heat and Fluid Flow, Vol. 32, pp. 107-116, (2011).

28. Niu, J., Fu, C. and Tan, W., "slip flow and heat transfer pf a Non-Newtonian nanofluid in a microtube", Plos one, Vol. 7, 99-106, (2012).

29. Hojati, M., Etemad, S.GH., Bagheri, R. and Thibault, J., "Rheological Characteristics of Non-Newtonian nanofluids: Experimental investigation", Internatinal Communications in Heat and Mass Transfer, Vol. 38, pp. 144-148, (2011).

30. Shayam, R. and Chhabra, R.P., "Effect of Prandtl number on heat transfer from tamdem square cylinders immersed in power-law fluids in the low Reynolds number regime", International Journal of Heat and Mass Transfer, Vol. 57, pp. 742-755, (2013).

31. J Han, C., Zhang, Y.M., "High performance heat transfer ducts with parallel broken and V-shaped broken ribs", International Journal of Heat and Mass Transfer, Vol. 35, pp. 513–523, (1992).

32. Kamali, R. and Binesh, A.R., "Numerical Investigation of Heat Transfer Enhancement Using Carbon Nanotube Non-Newtonian Nanofluids", Internatinal Communication in Heat and Mass Transfer, Vol. 37, pp. 1153-1157, (2010).

33. Brinkman, H.C., "The Viscosity of Concentrated Suspensions and Solution", J. Chem. Phys., Vol. 20, pp. 571–581, (1952).

34. Chon, C.H., Kihm, K.D., Lee, S.P. and Choi, S.U.S., "Empirical correlation finding the role of temperature and particle size for nanofluid (AL2O3) thermal conductivity enhancement", Appl. Phys. Lett., Vol. 87, pp. 1-3, (2005).

35. Mirmasomi, S. and Behzadmehr, A., "Numerical study of laminar mixed convection of a nanofluid in a horizontal tube using two-phase mixture model", Applied Thermal Engineering, Vol. 28, pp. 717-727, (2007).

36. Hadjiconstantinou, N.G. and Simek, O., "Constant-wall-temperature nusselt number in micro nano-channels", Transactions of ASME, Vol. 124, pp. 356-364, (2002).

37. Beskok, A. and Karniadakis, G.E., "Simulation of heat and momentum transfer in complex microgeometries", J. Thermophys Heat Transfer, Vol. 8, pp. 647-655, (1994).

38. Satapathy, A.K., "Slip flow heat transfer in an infinite microtube with axial conduction", Vol. 49, pp. 153-160, (2010).

39. Vandadi, V., Vandadi, A. and Aghanajafi., C., "Slip-Flow heat transfer circular microchannel with Viscous dissipation", IJRRAS, Vol. 6, pp. 176-181, (2011).

40. Akbari, M., Behzadmehr, A. and Shahraki, F., "Fully developed mixed convection in horizontal and inclined tubes with uniform heat flux using nanofluid", International Journal of Heat and Fluid Flow, Vol. 29, pp. 545-556, (2008).

41. Keshavarz, M., Hossein Haddad, S.M. and Darabi, M., "Modeling of Force Convection Heat Transfer of a Non-Newtonian Nanofluid in the Horizintal Tube Under Constant Heat Flux With Computational Fluid Dynamics", Internatinal Communications in Heat and Mass Transfer, Vol. 39, pp. 995-999, (2012).