Evaluation of the effect of chain association type on the textural characteristics of kappa- iota carrageenan mixed gel

مجله پژوهشهای علوم و صنایع غذایی ایران

Article 5, Volume 14, Issue 4 - Serial Number 52, September and October 2018, Pages 543-559   

Document Type: Research Article

DOI: 10.22067/ifstrj.v14i4.66898

Authors

Amir Jajarmi¹; Bahareh Emadzadeh^{* 2}; Rassoul Kadkhodaee³

¹Department of Food Nanotechnology, Research Institute of Food Science and Technology, Mashhad, Iran.

²Associate Professor, Research Institute of Food Science and Technology (RIFST), Mashhad, Iran

³Research Institute of Food Science and Technology (RIFST)

Abstract

Introduction: Carrageenans are a family of linear sulphated polysaccharides that have broad applications in the food sector and pharmaceutical industry. Based on the degree of sulphation (polyelectrolytes) in carrageenan, only Kappa and Iota carrageenan have the ability of forming a gel structure. The mechanical characteristics of their gels, however, is affected by the polyelectrolyte nature of their chains. Iota and kappa carrageenan provide elastic soft gel and brittle rigid one, respectively, in the presence of calcium and potassium salts as their favored ions; while their mixture provides a broad range of structures with unique textures. The combination of these two biopolymers would result in a broad range of unique textures for different applications. The aim of this Study was to determine the effect of chain association (molecular association) on the textural properties of kappa- Iota carrageenan mixed gel. The texture of gels was investigated through the puncture test to determine some properties including hardness, toughness, deformability modulus, resilience, yield point, and proportional limit. In addition, the stress relaxation test was applied to evaluate the effect of the chain association formed in the network on the stress decay parameter.

Materials and Methods: A commercial Kappa-carrageenan, Genugel type, and Iota- carrageenan, Genuvisco type without further purification were purchased from CP Kelco (Lille Skensved, Denmark). Potassium chloride (KCl) and calcium chloride dihydrate (CaCl2•2H2O) of analytical grade were purchased from Merck company. The mixtures were prepared in 2:1, 1.5:1.5 and 1:2 ratios and the final concentration of 0.3% w/w biopolymer. Both calcium and potassium chloride were added using a strategy adopted for each salt for keeping the same ionic strength of molar concentrations of 2.5, 5 and 7 mmol in the biopolymer dispersions. The mechanical properties of the gels were investigated using an XT. T2 Texture Analyzer (Stable Micro Systems, Surrey, UK). Peltier system was utilized in adjusting the temperature at 4oC. The samples were equilibrated at least 10 min before performing the test. Crosshead speed was adjusted at 10 mm/min to a 12 mm depth (50% from total length) from the surface of the samples using a 1 mm diameter cylindrical aluminum probe for puncture test and a 2 mm/min crosshead speed using a 75 mm diameter cylindrical aluminum probe in 20% strain was applied for the stress relaxation test during 60 second time interval. Pleg and Normand equation was applied for the determination of viscoelastic properties of samples.

Result & discussion: Among different methods in the mechanical study of biopolymer gel, the puncture test is a promising method due to its ability in applying normal and shear forces on and into the structure simultaneously. In the presence of calcium and Potassium salts, the same pattern in the puncture curve was observed with increasing of ionic strength in the medium. According to the chain association formed as a result of the ion type, the pattern shows a transient from the elastic to the plastic deformation with different limits. The hardness as a parameter that indicates a composite biopolymer network resistance to break up, showed a higher value for the network containing Potassium salt. It would be due to the formed intra chain association in the system. For calcium salt, the results revealed a small variation in the hardness parameter with increasing the ionic strength. The area under the curve of stress- time is defined as toughness of the structure. The network formed by the intra chain association in the presence of potassium shows a free chain movement which leads to a plastic deformation with absorbing more energy before breaking the gel structure. Concerning the type of chain association, higher values of deformability modulus in the gels containing calcium salt is reasonable. Resilience, yield point and proportional limit are the characters related to the network homogeneity and bond stretching. In the networks with no depletion region, applying an external force to the body would lead to a uniform change in the initial state of the structure. In this kind of netwoks, the force distributed in the whole structure uniformly and local stress is not created. The chain movement as a result of bond stretching, causes a back stress occurance in the structure. When the primary stress is eliminated, the accumulated back stress will make the polymer to return to its original form. Interweaving the network by the intra chain association will result in a homogenous network formation and subsequently, to a higher parameter values in the linear region. The large deformation measurements were performed through the stress relaxation test to study the response of the structure during the interval times and to evaluate the viscoelastic properties of biopolymers network. Longer stress decay time was observed for the network developed in the presence of Potassium salt. The result obtained by studying the stress decay rate was in agreement with the properties observed from the evaluation of the linear region in the puncture test. On the other hand, the deformability modulus values conform to the result from hypothetical asymptotic level of the normalized relaxation parameter.

Keywords

Chain association; Carrageenan gel; Textural properties; Puncture test; Stress relaxation test

References

Amici, E., A. H. Clark, V. Normand and N. B. Johnson (2002). "Interpenetrating Network Formation in Agarose− κ-Carrageenan Gel Composites." Biomacromolecules 3(3): 466-474.

Dumitriu, S. (2004). Polysaccharides: structural diversity and functional versatility, CRC press.

Gamero, M., S. Fiszman and L. Duran (1993). "Stress relaxation of fruit gels. Evaluation of models and effects of composition." Journal of food science 58(5): 1125-1128.

Gunasekaran, S., & AK, M. M. (2002). Cheese rheology and texture. CRC press.

Gregson, C. M., Hill, S. E., Mitchell, J. R., & Smewing, J. (1999). Measurement of the rheology of polysaccharide gels by penetration. Carbohydrate polymers, 38(3), 255-259.

Hermansson, A.-M., E. Eriksson and E. Jordansson (1991). "Effects of potassium, sodium and calcium on the microstructure and rheological behaviour of kappa-carrageenan gels." Carbohydrate Polymers 16(3): 297-320.

Imeson, A. (2011). Food stabilisers, thickeners and gelling agents, John Wiley & Sons.

Lai, V., P. L. Wong and C. Y. Lii (2000). "Effects of Cation Properties on Sol‐gel Transition and Gel Properties of κ‐carrageenan." Journal of food science 65(8): 1332-1337.

Lau, M., J. Tang and A. Paulson (2000). "Texture profile and turbidity of gellan/gelatin mixed gels." Food Research International 33(8): 665-671.

Li, L., R. Ni, Y. Shao and S. Mao (2014). "Carrageenan and its applications in drug delivery." Carbohydrate polymers 103: 1-11.

Liu, S. and L. Li (2016). "Thermoreversible gelation and scaling behavior of Ca 2+-induced κ-carrageenan hydrogels." Food Hydrocolloids 61: 793-800.

MacArtain, P., J. Jacquier and K. Dawson (2003). "Physical characteristics of calcium induced κ-carrageenan networks." Carbohydrate Polymers 53(4): 395-400.

Mao, R., J. Tang and B. Swanson (20. Texture properties of high and low acyl mixed gellan gels." Carbohydrate polymers 41(4): 331-338.

MOHSENIN, N. N. (1970). "Application of engineering techniques to evaluation of texture of solid food materials." Journal of Texture Studies 1(2): 133-154.

Montero, P. and M. Perez-Mateos (2002). "Effects of Na+, K+ and Ca 2+ on gels formed from fish mince containing a carrageenan or alginate." Food Hydrocolloids 16(4): 375-385.

Morris, E. R. (1990). Mixed polymer gels. Food gels, Springer: 291-359.

Morris, E. R., D. A. Rees and G. Robinson (1980). "Cation-specific aggregation of carrageenan helices: domain model of polymer gel structure." Journal of molecular biology 138(2): 349-362.

Morris, V. and P. Belton (1982). "Influence of the cations sodium, potassium and calcium on the gelation of iota-carrageenan." Progress in food and nutrition science.

Norziah, M., S. Foo and A. A. Karim (2006). "Rheological studies on mixtures of agar (Gracilaria changii) and κ-carrageenan." Food Hydrocolloids 20(2): 204-217.

Parker, A., G. Brigand, C. Miniou, A. Trespoey and P. Vallee (1993). "Rheology and fracture of mixed ι-and κ-carrageenan gels: Two-step gelation." Carbohydrate Polymers 20(4): 253-262.

Peleg, M. and M. Normand (1983). "Comparison of two methods for stress relaxation data presentation of solid foods." Rheologica Acta 22(1): 108-113.

Phillips, G. O. and P. A. Williams (2009). Handbook of hydrocolloids, Elsevier.

Saha, D. and S. Bhattacharya (2010). "Hydrocolloids as thickening and gelling agents in food: a critical review." Journal of food science and technology 47(6): 587-597.

Thrimawithana, T., S. Young, D. Dunstan and R. Alany (2010). "Texture and rheological characterization of kappa and iota carrageenan in the presence of counter ions." Carbohydrate Polymers 82(1): 69-77.

Wang, M., X. Qiu and X. Zhang (2007). "Mechanical properties of super honeycomb structures based on carbon nanotubes." Nanotechnology 18(7): 075711.

Gunasekaran, S., & AK, M. M. (2002). Cheese rheology and texture. CRC press.

Gregson, C. M., Hill, S. E., Mitchell, J. R., & Smewing, J. (1999). Measurement of the rheology of polysaccharide gels by penetration. Carbohydrate polymers, 38(3), 255-259